Community prints.

Apart from the same artifact that appeared during the last sample, the print quality is overall very good, a lot of warping is identified.

— Rob

Tried another printer and the new Orcaslicer version for the first time. Noticed a lot of underextrusion with the same converted settings as PTSample 8 and 14. Also a new artifact appeared between corners.

— Rob

Just warping, no delamination. Underside looks flawless

— Cocoanix

— ja

Went insanely well but after floor layer was placed it just warped. Will try without floor layers.

— Cocoanix

Good except for warping

— ja

Basically perfect (dirty nozzle caused black strings in print). I printed this for my youtube video that is in production.

Very low perimeter quality due to extremely low layer time.

— ja

Zig zag behaviour unexpectedly stops towards the end of the overhang.

— ja

Very similar results to 13, seems to pull back on the material

— Rob

Almost perfect again, wanted to replicate the result from PTSample8, same result is found.

— Rob

Same weird starting lines, looks like overextrusion but the parameters are roughly the same. *PATTERN USED IS "SMART", unlike photo*

— Rob

Weird starting lines, overall not very good quality though shape is properly retained

— Rob

Still shows signs of overextrusion, overall looks clean, nozzle still dragging across the layers.

— Rob

Shows signs of overextrusion, but overall looks clean. Nozzle is dragging across the layers.

— Rob

Shows signs of overextrusion, nozzle is dragging across the layers, causing them to disconnect near perimeter

— Rob

Almost perfect, not quite, perimeter on a different level than the rest of the overhang

— Rob

Waves not connected to the perimeter on a couple points

— Rob

Waves not connected to the perimeter on a couple points

— Rob

Generally dimensional inaccurate, perimeter on different level, edges not connected

— Rob

Very poor quality, not dimensionally accurate at all, a lot of underextrusion.

— Rob

Very poor quality, not dimensionally accurate at all. A lot of underextrusion

— Rob

Takes somewhat of a form, but still does not resemble the model

— Rob

Does not take form at all. Poor adhesion between layers

— Rob

— ja

— ja

— ja

— Dennis

— Dennis

— Dennis

— Dennis

— Dennis

— Dennis

— Dennis

— Dennis

— Dennis

— Dennis

— Dennis

— Dennis

— Dennis

— Dennis

— Dennis

— Dennis

— Dennis

— Dennis

— Dennis