07 Nov 2026 Good
Printer Bambu Lab P1S
WaveOverhangs -
Counterbore test (waveoverhangs #187), printed on a Bambu P1S with a 0.4 mm nozzle, PLA, using the Python plugin port orca_arc_overhang (odggg/orca-arc-overhangs, PR #1) on OrcaSlicer 2.5.0-rc. Waves covered the whole counterbore ring with no gaps or sagging. A few thin strings of filament formed at the end of the smaller inner circle, which I cleaned off by hand. Tip: set "Bridge counterbore holes" to None in Orca. With "Partially bridged", Orca prints supported straight strips that the plugi
by persano